Boxform
Posted: Fri Jun 08, 2012 9:58 am
like this, still building the tops
like this, still building the tops
Page 1 of 1
like this, still building the tops
Re: Boxform
Posted: Fri Jun 08, 2012 3:17 pm
these are the parts i need to cut, modeled in Sketchup. they fit within a 20"x40" envelope with about an inch margin.
thoughts?
Re: Boxform
Posted: Fri Jun 08, 2012 10:17 pm
Looks like it should work fine. You'll probably want to insert tabs between your pieces when you run it through CAM so they don't start flapping about, but that's easy enough.